Major Chips Description 2-75
Table 2-9T62.055.C Pin Descriptions
Pin Name Pin Type Pin No. Descriptions
BATTLED O13 This signal is an open collector sink signal to drive LED2. The
LED current is limited by a series resistor of 1K.
BMCVCC O14 This a 5 volt supply for powering the LEDs. It should not be used
for any other purpose.
ADVDD O18 This is a 5 volt power line for the analog circuits and display
LEDs on the inverter board.
AUDGND GND 19, 20 This is the return ground for the microphone circuit. It should not
be connected to VGND or other circuit on the inverter board.
MIC_OUT O21 This is the output of the microphone preamplifier circuit.
N.C. -10, 11,
15, 16,
17
Non-connected.
CN3 connector signals
MIC-CON I1Microphone input
N.C. -2Non-connected.
AUDGND GND 3This is the return ground for the microphone circuit. It should not
be connected to VGND or other circuit on the inverter board.
2.9.2 T62.088C
2.9.2.1 Pin Diagram
Figure 2-13 T62.088.C Pin Diagram
2.9.2.2 Pin Descriptions
Table 2-10 T62.088.C Pin Descriptions
Pin Name Pin Type Pin No. Descriptions
CN1 connector signals
VOUT1 O1Lamp, HV
NC 2
VOUT2 O3Lamp, LV
CN2 connector signals