iii. Connecting to Analog Components:
You can connect the headphones to an analog device and listen to Dolby Pro Logic recordings and compact discs.
| III | Charging |
| the | |
| Batteries |
TRANSMITTER |
|
|
| ||
CHANNEL |
|
|
|
| |
A | B C |
|
|
|
|
AC 7V |
|
|
|
|
|
DIGITAL 1 | DIGITAL 2 | ANALOG 3 |
|
|
|
|
|
| VCR |
|
|
|
|
| OUTPUT | INPUT | |
|
|
| RIGHT | LEF T V ID EO | RIGHT LEF T V ID EO |
|
| ANTENNA | TV |
|
|
|
| IN | OUT |
|
|
1.Connect one end of the Analog Audio Cable (not included) to the
2.Connect the other end of the Analog Audio Cable to the
Note: The rechargeable batteries included with this product must be charged for 10 hours before use.
i.Inserting the Batteries into the Headphones:
1. | Remove the Battery Compartment |
| Cover (I) by simultaneously |
| depressing the tab and pulling up on |
| the cover. |
2. | Pull the cloth strip across the Battery |
| Compartment (H) so the |
| Rechargeable Batteries (P) can be |
| inserted over the strip. |
3. | Insert the Rechargeable Batteries (P) |
Note: When using a device with a variable analog output, make sure the volume level is set to 1/2 to 2/3 volume. When using a variable level output, noise may occur if the signal level is too weak or too strong. Adjust the volume to eliminate the noise.
+ | – |
+ |
– | + |
– |
observing the polarity ("+" and |
diagrammed inside the Battery |
Compartment (H). |
4. Replace the Battery Compartment |
Cover (I). |
iv. Connecting the Power Supply:
ii. Charging the Batteries within the Headphones: |
TRANSMITTER
CHANNEL | ||
A | B | C |
AC 7V
DIGITAL 1 DIGITAL 2 | ANALOG 3 |
1.Insert the 2.5mm barrel connector from the AC Power Supply (O) into the AC Input Jack (E).
2.Plug the AC Power Supply
(O) into a standard electrical wall outlet.
1. Place the headphones onto the |
Transmitter, making sure the |
charging contact on the left earcup is |
sitting properly on the charging post |
of the transmitter. |
2. | Allow the Rechargeable Batteries (P) |
| to fully charge for 10 hours before |
| using for the first time. |
3. | Place the headphones on the |
| transmitter when not in use. This will |
| ensure the batteries are always fully |
| charged for hours of entertainment. |
| The Rechargeable Batteries (P) use |
Note: Make sure the electrical outlet is not a switched outlet - usually designed to control a lamp - and remains ON at all times. This is important, as the transmitter base charges the headphones when not in use.
- 4 -
SS 1 2 3 | |
| recharging without the memory |
| effect of |
For customers in the USA and CANADA
RECYCLING NICKEL
Nickel
Acoustic Research participates in the Rechargeable Battery Recycling Corporation (RBRC) program. If you need advise on proper disposal of the included
Caution: Do not handle damaged or leaking batteries.
- 5 -