| IR210L IrDA Motherboard Adaptor |
The Wireless Connectivity Expert | User’s Manual |
10)TROUBLE SHOOTING
For help on general and miscellaneous problems you may be experiencing with your printing, refer to the following pages for possible solutions. Look up your problem and try the solution as following.
SYMPTOM | PROBLEM | Solution |
Can not establish link | 1. The two IR devices are | 1. Properly align them again. |
(General) | not aligned properly. | 2. Move one device to a proper |
| 2. Distance is too near or | distance. |
| far. | 3. Enable the device by IR monitor. |
| 3. The device is inactivated. | 4. Refer to Uninstallation Guide to |
| 4. The device is not | remove the device, then reinstall |
| installed properly. | again. |
| 5. BIOS setting is wrong | 5. Correct BIOS setting. |
|
|
|
File Transfer between | The infrared communication | Check to find out the source of |
is interfered. For example, | interference and eliminate it before | |
something blocks out the | trying again. | |
host computer stops | infrared beam or the burst | If you were restoring data, simply |
before finishing up and | of string light source, etc. | try again. |
an error message | Software does not support | If you were doing backup |
appears. | the IrDA controller chip on | something the PDA does not reset |
| the motherboard. | its flags and keeps stopping at the |
| Serial port is occupied and | same position unless you press the |
| not available for IR | RESET button once. Be very |
| transmission. | careful. DO NOT initialize (press |
|
| ON key and RESET button at the |
|
| same time) your PDA. Otherwise |
|
| you may lose all your data. |
|
| Make proper model # selection in |
|
| the software as specified in your PC |
|
| system User’s manual. |
|
| Make sure to disconnect modem, |
|
| etc. from the serial port to make it |
|
| available for IR transmission. |
|
|
|
Copyright | Page 11 of 14 | Feb. 14, | 2006 |
|
| Ver. | 1.5.1 |