ACTiSYS ACT-IR210L 6)WINDOWS 98 UNINSTALLATION GUIDE

	IR210L IrDA Motherboard Adaptor
The Wireless Connectivity Expert	User’s Manual

Note: If you do not change your computer BIOS setting, STOP here and go to Chapter BIOS SETUP.

Note: If your computer system has installed with other device on the same com port before, you MUST uninstall the devices first. ACT-IR210L would NOT work with your system anymore if the devices are uninstalled improperly because some drivers are still there and can cause conflicts with ACT-IR210L driver.

Note: If your computer system has installed any IrDA device before, ACT-IR210L would NOT work with your system. You HAVE to reinstall your Windows again.

If your motherboard has built-in infrared I/O controller or super I/O chip, Windows will automatically install the driver if the IrDA is enabled in BIOS settings.

Plug the ACT-IR210L to the Din8 connector and it will work.

If your computer operates under Windows 98 O.S, you may need to insert Windows 98 CD to your driver.

Following are the instructions to properly uninstall the ACT-IR210L under Windows 98, Me, 2000, XP.

6)WINDOWS 98 UNINSTALLATION GUIDE

1.Boot up your computer system.

2.Click Control Panel.

3.Double click System Icon.

4.Click Device Manager tab.

5.Highlight Infrared Communication Device, and then click Remove.

6.Click OK in the Confirm Device Removal box.

7.Highlight (Generic Infrared Serial

Port or Dongle), then click Remove.

8.Click OK in the Confirm Device Removal.

 Copyright 2003-2006 ACTiSYS Corp.	Page 6 of 14	Feb. 14,	2006
		Ver.	1.5.1