ACTiSYS ACT-IR210L 1)INTRODUCTION, 2)PARTS CHECK LIST, 3)SYSTEM REQUIREMENTS, 4)BIOS SETUP, 5)WINDOWS 98/ME/2000/XP INSTALLATION GUIDE, IR FUNCTION DUPLEX: HALF

	IR210L IrDA Motherboard Adaptor
The Wireless Connectivity Expert	User’s Manual

1)INTRODUCTION

This document provides instructions to install the ACT IR210L IR Dongle along with Windows 98/ME/2000/XP device driver. It is assumed that the user is familiar with the basic operation of Window 98/ME/2000/XP.

2)PARTS CHECK LIST

When you unpack the package, the following items should be found.

1.ACT-IR210L Adapter

2.5 pins Motherboard Connector

3.User’s Guide

4.5 pins to 6 pins changer

3)SYSTEM REQUIREMENTS

To use ACT-IR210L, your computer MUST meet the following requirements.

1.Window 98/ME/2000/XP.

2.Built in infrared I/O controller or super I/O chip on the motherboard with infrared connector available and documented in the user’s manual.

4)BIOS SETUP

You MUST setup BIOS FIRST. It assumed that your IR Dongle would be installed to serial Com port 2 before install the device driver.

1.Choose PNP & PCI from

BIOS SETUP

PNP OS Installed: NO

Resource Controlled by: Manual

2.Choose Integrated Peripherals from BIOS SETUP

Onboard UART2 Serial Port 2 : 2F8H/IRQ3

Onboard IR function: SIR, HPSIR or IrDA or 3/16 baud

RXD,TXD Active: Hi,Lo

IR Transmission delay: Disable

IR FUNCTION DUPLEX: HALF

IR Use Pins: IR-RX2,TX2

5)WINDOWS 98/ME/2000/XP INSTALLATION GUIDE

 Copyright 2003-2006 ACTiSYS Corp.	Page 5 of 14	Feb. 14,	2006
		Ver.	1.5.1