ErasingDiagnosticTroubleCodesandData
Erasing allows the PocketScanTM Code Reader to delete the codes and I/M Monitor status from the vehicle’s computer modules.
IMPORTANT
!WARNING
Only Erase Diagnostic Data after checking system completely and writing down results.
Avoid Cooling Fan! Fan may turn on during test.
1.Turn Ignition Key to the Off Position.
| F |
F | |
O |
|
ON
2. Locate and Plug in Data Link Connector (DLC.)
NOTE: The data link connector
should be located under the dashboard on the
driverside of the vehicle.
If the data link connector is not located under the dashboard as stated, a label describing the location of the data link connector should be there.
3.Observe Display toggles between “Pocket” and “Scan”.
Scan
4.Turn Ignition Key to the ON Position leaving Engine Off.
NOTE: Make sure that the Ignition Key is ON and NOT in the Accessory Position.
ON
F
F
O
10
