ReadingDiagnosticTroubleCodesandData
!WARNING
Avoid Cooling Fan! Fan may turn on during test.
1.Turn Ignition Key to the Off Position.
| F |
F | |
O |
|
ON
2. Locate and Plug in Data Link Connector (DLC.)
NOTE: The data link connector
should be located under the dashboard on the driverside of the vehicle.
If the data link connector is not located under the dashboard as stated, a label describing the location of the data link connector should be there.
3.Observe Display toggles between “Pocket” and “Scan”.
NOTE: For a correct reading for
Diagnostic Trouble Codes and I/M Monitor Status, ignition key must be in the ON position and Engine does
not require starting.
To get a correct reading for MIL Status, Engine must be started.
4.Start Engine.
5.PressREAD/Scroll Down Key and Release.
7