Philips PT-LB10VU Projector Driver Application Note, Projector Control, Volume and Power Control

Projector Driver Application Note

Panasonic PT-LB10VU

Revision A

This document describes the SmartPanel Projector Driver for the Panasonic PT-LB10VUprojector. This driver is also appropriate for use with the Panasonic PT-LB10VUprojector. For more information on configuring and using the Panel see the SmartPanel Configuration and Installation Manual.

I. PROJECTOR CONTROL

A. Volume and Power Control

Volume control on the Panasonic is absolute.

B. Input Selection Mapping

The following table specifies the factory-preset input mapping for this Driver. The Configuration Utility can be used to customize these settings your installation.

Selection 1: VIDEO

Selection 2: S-VIDEO

Selection 3: RGB

Selection 4: NETWORK

Input choices available for the Panasonic with this Driver are VIDEO, S-VIDEO, RGB and

NETWORK.

RGB	NETWORK
S-VIDEO	Projector	Volume
VIDEO	ON
	Ready
	Warm-up
	OFF

C. Hidden Function Mapping

The following table specifies the factory preset hidden function mapping for this Driver. The Configuration Utility can be used to customize these settings your installation.

Selection 1: AV MUTE

Selection 2: ENTER

Selection 3: ADJUST LEFT

Selection 4: ADJUST RIGHT

Off: MENU

Volume Up: ADJUST UP

Volume Down: ADJUST DOWN

	ADJUST	ADJUST	ADJUST
ENTER	LEFT	RIGHT	UP
			Projector	Volume
MUTE			ON
			Ready
			Warm-up
			OFF
		MENU	ADJUST
			DOWN

Hidden functions names are based on the Panasonic remote and controls on top of the projector. Adjust controls navigate through onscreen menus. Hidden functions are accessed by pressing the indicated key while the holding the On key down.

AV MUTE is a toggling A/V mute. AUTO SETUP only works when RGB input is selected.

03/28/05 SP Controls reserves the right to modify specifications without notice at any time.