Philips quick start Quick Start Reference Sheet, Panasonic PT-LB10VU Revision A, 1.RS-232

Quick Start Reference Sheet

Panasonic PT-LB10VU

Revision A

NOTE: This one-page document is intended only as a quick reference for installation – please read the SP Controls Application Note for a complete description of this projector driver prior to installation.

I. Driver Features

1.Input Selection Mapping

Selection 1: VIDEO

Selection 2: S-VIDEO

Selection 3: RGB

Selection 4: NETWORK

2.Hidden Function Mapping (Default Configuration)

Using the ON button as a shift key, press the following buttons to access the specified projector features.

Selection 1: AV MUTE

Selection 2: ENTER

Selection 3: ADJUST LEFT

Selection 4: ADJUST RIGHT

Off: MENU

Volume Up: ADJUST UP

Volume Down: ADJUST DOWN

3. Other Driver Features

Power Status Feedback Method	RS-232 Power Polling
Control Wiring:	RS-232 and IR-Emitter

II. Wiring Specifications

NOTE: The Panasonic PT-LB10VU projector serial port is a female 8-pin mini-DIN. This document provides instructions for terminating the RS-232 control cable directly onto an 8-pin mini-DIN connector. If you wish to terminate the control cable on a standard DB9 connector, an adaptor cable may be separately ordered from Panasonic (Panasonic part no. ET-ADSER).

1.RS-232:

Wire the Panel RS-232 port to a male 8-pin mini-DIN as follows: RX to 5

TX to 3 GND to 4

Connect this male DB9 to the projector port labeled SERIAL.

2.Infrared Emitter:

Wire the Panel IR/Serial port to a female 1/8" Mini as follows:

IR/SER to	tip
GND to	ring

Connect to the included IR Emitter and attach the emitter bud to any projector IR window.

03/28/05 SP Controls reserves the right to modify specifications without notice at any time.