Acu-Rite 2048 Troubleshooting, Problem, Possible Solution, reception, Outdoor, No outdoor sensor

Troubleshooting

	Problem			Possible Solution
				If the wireless signal indicator shows no bars:
				• Relocate the display unit and/or the outdoor sensor. The
				units must be within 330 ft (100 m) of each other.
No outdoor sensor				• Make sure both units are placed at least 3 feet
				(.9 m) away from electronics that may interfere with
	reception			the wireless communication (such as TVs, microwaves,
			no bars	computers, etc).
				• Use standard alkaline batteries (or lithium batteries in
				sensor when temperature is below -4ºF/-20ºC). Do not
				use heavy duty or rechargeable batteries. NOTE: It
				may take up to 20 minutes for display unit and sensor to
				synchronize after batteries are replaced.
				Flashing of the outdoor temperature is generally an
				indication of wireless interference.
				1. Bring both the sensor and display unit indoors and
		Outdoor		remove batteries from each.
temperature				2. Make sure the A-B-C switch on both units match.
is flashing or				3. Reinstall batteries in the outdoor sensor.
showing dashes				4. Reinstall batteries in the display unit.
				5. Let the units sit within a couple feet of each other
				for about 20 minutes to gain a strong connection.
				Sometimes changing to a different channel can help.
				• Weather Forecast icon predicts conditions for the next 12
				to 24 hours, not current conditions.
				• Has Learning Mode icon disappeared from the display
				unit? Learning Mode must complete before forecast and
Inaccurate forecast				pressure will be accurate.
				• Allow unit to run continuously for 33 days. Battery
				removal or resetting the display unit will restart Learning
				Mode. After 14 days, forecast should be fairly accurate,
				however Learning Mode calibrates for a total of 33
				days.
Inaccurate				• Make sure both the display unit and sensor are placed
				out of direct sunlight and away from any heat sources or
temperature				vents (see page 9).
or humidity				• Make sure both units are positioned away from moisture
				sources (see page 9).

11