Acu-Rite 2048 Display Unit Setup, Plug in Power Adapter, Set the A-B-C Switch, A B C

Display Unit Setup

1Set the A-B-C Switch

Locate the A-B-C switch inside the battery compartment. Set the A-B-C switch to A, B or C. You must select the same letter choices for both the display unit and the sensor in order for the units to synchronize.

2Plug in Power Adapter

For the best performance, plug in the power adapter as the main power source for this product.

1A-B-C Switch set to match sensor

A B C

2 Plug in

Power Adapter

3Install or Replace Backup Batteries (optional)

1.Remove the battery compartment cover.

2.Insert 3 x AA alkaline batteries into the battery compartment, as shown. Follow the polarity

(+/-) diagram in the battery compartment.

3.Replace the battery cover.

3 Install Backup

Batteries

3 AA batteries (optional)

IMPORTANT: Batteries are a backup power source to preserve records in the event of a power outage.

Power adapter is recommended as the primary power source to enjoy the full functionality of this product.

PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY SAFE WAY AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS.

BATTERY SAFETY: Clean the battery contacts and also those of the device prior to battery installation. Remove batteries from equipment which is not to be used for an extended period of time. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the device. Dispose of used batteries properly. Only batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in fire, as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (alkaline/standard). DO NOT use rechargeable batteries. DO NOT recharge non-rechargeable batteries. DO NOT short-circuit the supply terminals.

7