Adaptec APA-1350 manual Installing the MiniSCSI

MiniSCSI 1350 User’s Guide

Installing the MiniSCSI 1350

Follow the steps below to install the MiniSCSI 1350 and connect your SCSI devices to it. Refer to Figure 1 on page 3 for an illustration of a typical installation.

1Connect the 50-pin interface plug to the SCSI interface socket on your peripheral device.

2Plug the 25-pin interface plug into a parallel-printer connector on your computer.

3Optional: If a printer cable is already attached to the connector, unplug it and connect it to the 25-pin socket on the MiniSCSI 1350.

Note: This is a pass-through printer connection that will allow printing while your SCSI peripheral is in use.

4Ensure that your SCSI peripheral is properly terminated and then switch on power to your SCSI peripheral. The green power indicator on the MiniSCSI 1350 will now be illuminated and you are ready to install the software.

2