Page 3 of 6
Table
FIELD | TYPE | OPTIONS | DESCRIPTION | DEFAULT |
Unit Service State | Toggle | IS | Places the unit in service and allows | OOS |
|
|
| equipment alarm reporting by the MPU. |
|
|
|
| Must be set to IS for reporting of equipment |
|
|
|
| alarms. |
|
|
|
|
|
|
|
| OOS | Removes unit from service and stops |
|
|
|
| equipment alarm reporting by the MPU. |
|
|
|
|
|
|
T1 Provision | Toggle | YES | Brings up T1 default settings and allows | NO |
|
|
| configuration changes. |
|
|
|
|
|
|
|
| NO | No configuration changes allowed. |
|
|
|
|
|
|
T1 Service State | Toggle | Leave this field at OOS at this time to avoid undesirable reporting of alarms. Set this field to IS | ||
|
| after completing the configuration of the remaining fields. |
| |
|
|
|
|
|
Line Code | Toggle | AUTO | When the RLX line code is set to AUTO, | AMI |
|
|
| the module senses the line code and |
|
|
|
| switches from AMI to B8ZS if an encoded |
|
|
|
| signal is detected. After switching to B8ZS, |
|
|
|
| the RLX stays locked in this line code until |
|
|
|
| an LOS is detected at both DS1 inputs. |
|
|
|
|
|
|
|
| AMI | Alternate Mark Inversion |
|
|
|
|
|
|
|
| B8ZS | Bipolar |
|
|
|
|
|
|
Framing Format | Toggle | AUTO | The system automatically detects, | AUTO |
|
|
| establishes, and displays |
|
|
|
| the correct frame format (UNFRAMED, FT |
|
|
|
| ONLY, SF, or ESF). |
|
|
|
|
|
|
|
| UNFRAMED | Unframed data pattern |
|
|
|
|
|
|
|
| Ft ONLY | Used for SLC framing |
|
|
|
|
|
|
|
| SF | Super Frame |
|
|
|
|
|
|
|
| ESF | Extended Super Frame |
|
|
|
|
|
|
Network DS1 Source | Toggle | NRZ | This tells the Craft that the network DS1 | NRZ |
|
|
| source is at the backplane from the DS3 |
|
|
|
| MUX. |
|
|
|
|
|
|
|
| BIPOLAR | This tells the Craft that the network DS1 |
|
|
|
| source is at the bipolar DS1 interface. If |
|
|
|
| you select this option when you are in a |
|
|
|
| Broadband chassis, you will cut off the DS1 |
|
|
|
| signal. This option is used in the Loop |
|
|
|
| Extender system. See Section 4 of this |
|
|
|
| manual for information about the Extender |
|
|
|
| Card. |
|
|
|
|
|
|
|
|
|
| (continued) |
© 2000, ADC Telecommunications, Inc.