450412-4 www.amdry.com 9

Temperature Sensor Bracket

This is located inside the dryer in the lint compartment
above the lint screen. This bracket consists of 2 devices.
One is a temperature sensor probe and the other is a high
limit thermostat, which is set at 225º F (107º C).

Lint Screen

The lint screen is located in the front of the dryer in the lint
coop assembly. To clean the lint off the screen simply
brush the screen clean. The lint screen must be kept clean
in order for the dryer to operate properly and efficiently.
Inspect the screen for tears and replace as needed.

Lint Drawer Switch

The lint drawer switch is located in the lint compartment
and attached to the side of the lint coop. The lint door
switch ensures that the dryer will operate only when the lint
drawer is completely closed. This is a safety device and
should never be disabled.
!
!
Servicing _____________________________

Introduction

All electrical and mechanical service or repairs should be
made with the electrical power to the dryer disconnected
(power off).
WARNING: Personal injury could result.
The information provided in this section should not be
misconstrued as a device for use by an untrained person
making repairs. Service work should be performed by
competent technicians in accordance with local, state, and
federal codes. When contacting the factory for assistance,
always have the dryer model and serial numbers available.
CAUTION: Observe all safety precautions
displayed on the dryer or specified in this
manual before and while making repairs.
Before considering replacement, make sure that all
connectors are in place and making proper contact.

Computer Controls

Microprocessor Computer Board Replacement
Discontinue electrical power to the dryer.
Unplug keypad ribbon from rear of the computer.
Unplug all wiring harnesses connected to the computer
board.
Remove the 2 screws securing the computer to the
computer panel. Remove the computer by pulling the other
2 corners off the clinch studs.
Install new computer by reversing this procedure.
Keypad Label Assembly Replacement
Discontinue electrical power to the dryer.
Unplug keypad ribbon from rear of the microprocessor
computer.
Slowly peel off and remove keypad label assembly from
control panel.
Peel paper backing off new keypad label assembly.
Holding the new keypad label assembly close to the panel,
insert the keypad ribbon through the rectangular slot in the
control panel. Align label assembly into position by
matching the red viewing window on the label to the
rectangular cutout in the panel and gently press into place.