ADC and V35, RS-232/V24, X21 86

ADCP-50-304 • Issue 19 • June 1999 • Section 7: Operation

6.18.2 Module Position Entries

Some displays are instructions to enter the numerical module positions of A/B Switch Modules. To enter module numbers enter each number, separated by commas (Example: 3, 7, 11, 14) and press RETURN. The comma is always used as an input delimiter.

Two or more A/B Switch Module numbers in a sequence may be entered as a group by entering the lowest and highest numbers in the sequence, separated by a dash (Example: l-4). Entering 3- l5 will select modules 3 through 15. To enter all module numbers, only the letter A needs to be entered.

6.18.3 Control Key

The Ctrl X key may be pressed at any time during TLKxx operation to return control to the previous menu or deselect the chassis.

6.18.4 Status Displays

Various types of switch displays occur frequently in establishing switch configurations. These are described in Table 7-2.

	Table 7-2. Status Displays

STATUS DISPLAY	DISPLAY DEFINITION
Status Display #1
Chassis No. Xx	Chassis No. XX — XX = the chassis number for which status is displayed.
Module # 1 2 3 4 5 6 7 8	Module # — Module numbers on selected chassis for which switch status
9 10 11 12 13 14 15	is displayed. Module 0 is defined as the module in the leftmost position in
	the chassis.
Sw Status a/b/n/m/l/q/-	Sw Status — Current switch status on each of the indicated modules.
	a — Equipment channel A is selected on A/B Switch Modules.
	b — Equipment channel B is selected on A/B Switch Modules.
	n — Normal Mode is selected on Test Access Modules.
	m — Monitor Mode is selected on Test Access Modules.
	l — Line Mode is selected on Test Access Modules.
	q — Equipment Mode is selected on Test Access Modules.
	- — Indicates blank slot (not occupied by any module).
Failed Act	Failed Act — Previous command did not execute correctly.
	^ — Indicated module failed to perform command action.
	Blank - Indicated module completed command action.

Page 7-11