ADCP-50-304 • Issue 19 • June 1999 • Section 7: Operation

 

Table 7-3. Chassis Selection and Configuration via TLKxx Command

 

 

ACTION DISPLAY

DISPLAY DEFINITION

Enter:

 

TLKxx

Request to talk with chassis number xx, with xx equal to any chassis

 

 

number from 00 to 15. (Two digits must always be entered for

 

 

chassis number.)

Entry of TLKxx displays:

 

GS application

The selected chassis has been configured for Application

xxxxxxxxxxx on-line

xxxxxxxxxx (name of up to eleven characters). This is displayed

 

 

only after use of the GS selection.

 

or

 

GS application

An attempt was made to configure the selected chassis for Applica-

xxxxxxxxxxx failed

tion xxxxxxxxxxx, however the chassis was not correctly configured.

 

 

This is displayed only after use of the GS selection.

followed by:

Switch status as defined in Table 7-2.

Chassis No. XX

xxxxxxxxxxx Application

 

Module # 0 l 2 3 4 5 6 7 8 9

 

10 11 12 13 14 15

 

Sw Status

 

Select Operation

Allows entry of switch and setup conditions.

l.

Switch

 

2.

Setup

 

3.

Status

 

Enter switch and setup

 

conditions as described in

 

Figure 7-2and Figure 7-3

 

and in Table 7-4.

 

 

 

 

6.19.1 Changing Switch Status

All menus and selections involved in establishing access module switch configurations are shown in Figure 7-2and defined in Table 7-4. The Main Menu, Select Operation, immediately follows the opening status display or completion of a previous operation.

6.19.2 Saving a Current Configuration

Up to five different switch configurations can be stored in memory for use at a future time. All displays and actions involved in storing of a configuration after it has been established are shown in Figure 7-3and defined in Table 7-5. Procedures for selecting and using a stored configuration are defined in Figure 7-2and Table 7-4.

The first menu in saving a current configuration is Select Operation, which immediately follows the opening status display or completion of a previous operation.

6.19.3 Select Operation Menu

The main menu used for establishing switch configurations is the Select Operation Menu. This is the first menu displayed after the status display.

Page 7-13

© 1999, ADC Telecommunications, Inc.