Adcom GTP-602 manual Auxiliary Analog Inputs, Tape Inputs/Outputs, 13 12V DC Trigger, Power Switch

Use a twin RCA-to-RCA lead to con- nect the CD player’s left and right ‘Audio Outputs’ to this input.

[9] Auxiliary Analog Inputs

Input for any line-level signal source. Use a twin RCA-to-RCA lead to con- nect the CD player’s left and right ‘Audio Outputs’ to this input.

[10] Tape Inputs/Outputs

Connections for analog recording and playback to an audio tape recorder of any type, such as a cassette, reel- reel, DAT, MD or CD-R. Using twin RCA-to-RCA leads, connect to the left and right ‘Audio Output’ of the tape machine to the TAPE IN connec- tors for playback. Connect the left and right ‘Audio Input’ of the tape machine to the TAPE OUT connectors for recording.

[13] 12V DC Trigger

To facilitate remote turn-on and turn-off of other components (power amplifiers, for example), this 3.5mm mini-jack provides a constant signal (12 volts DC) whenever the GTP-602 is fully powered. When the GTP-602 is turned off (via the front panel switch) or placed in standby mode (via the

[16] Power Switch

The rear panel power switch should be turned off if the system will not be in use for an extended period of time. When the power switch is in the off position the GTP-602 is not using any power from the AC wall circuit. This switch must be on for the GTP-602 to operate in the “stand-by” mode.

[17] AC Power Cord

After you have completed all con- nections to the amplifier, plug the AC line cord into a “live” wall socket. Use only the supplied power cord or equivalent.

[11] Phono Inputs

Input for a phono (record) player (analog audio signal) Use a twin RCA- to-RCA lead to connect the phono- player’s left and right ‘audio outputs’ to this input.

[12] IR Input

The IR input allows hook up of an external IR sensor that sends IR infor- mation to the microprocessor in the GTP-602. This feature can be very use- ful if the GTP-602 is placed behind a non transparent door or is used with an after market remote control system.

“power” button on the remote con- trol), the jack has no output.

[14] Main Audio Outputs

Before making any connections, check that the GTP-602 and the power amplifiers it will be connected to are switched off. Connect the RCA-to-RCA leads from the GTP-602 to your exter- nal amplifiers. The three pairs of out- puts all carry the same signal.

[15] RS232 Control (DB 9)

Allows control of the GTP-602 via com- puter or home automation system.

ADCOM GTP-602 Owner’s Manual 9