Addonics Technologies manual Addonics Technologies, Model ADSAIDE44 Installation Guide

ADDONICS TECHNOLOGIES

Model: ADSAIDE44

Installation Guide

Front View

44-pin IDE Connector

SATA Power and

Master, Slave &Data Connector

Cable Select

Jumpers

Pin 1 Marker

2.Connect the converter board to the SATA connector of the hard drive.

3.(Optional) Connect the IDE ribbon cable to the 44-pin connector on the converter. The red edge of the ribbon cable needs to line up to pin 1 marker of the 44-pin connector. The other end of the ribbon cable will be connected to your motherboard’s 44-pin IDE channel.

Jumper Settings

Master	Slave	Cable Select
Note:	To set the SATA hard drive as a Master Device
	when connected to an IDE channel, you need to
	short the top pins located on the converter by

placing a jumper. As a Slave Device short the middle pins.

1.Locate the SATA connector of your 2.5” SATA drive.

15-pin SATA Power &

7-pin Data Connector

TECHNICAL SUPPORT

Email:http://www.addonics.com/sales/

Internet: http://www.addonics.com

Technical Support (8:30 am to 6:00 pm PST)

Phone: 408 573-8580

Email: http://www.addonics.com/support/ticketid/