Manuals
/
Addonics Technologies
/
Computer Equipment
/
Computer Accessories
Addonics Technologies
R1ESU3F manual Contact Us, Phone Fax
Models:
R1ESU3F
1
10
10
Download
10 pages
32.7 Kb
3
4
5
6
7
8
9
10
<
>
Install
Configuring the Port Multiplier Using Switches Resetting the RAID
The RAID and Disk Information screen shown when the program was launched will now show the Port Multiplier with an Array. The drives are now listed as M0-M4, indicating they are members of the array. If spares are present individual drives added later, and the EZ switch is in the OFF position, they would be listed as S0, S1, etc. On the right pane, the RAID Level, status, capac- ity and members that are online are listed. Status will show “Normal” all mem- bers on line, “Degraded” a fault-tolerant array with a drive failure needing service, “Rebuilding” a fault-tolerant array in the process of reconstructing lost data onto a spare or “Broken” an array that has lost all data
Setting or Modifying the RAID Mode
Front Door keys Rack Mounting kit Desktop accessories
JBOD Mode Individual Drives
Page 10
Image 10
CONTACT US
www.addonics.com
Phone:
408-573-8580
Fax:
408-573-8588
Email: http://www.addonics.com/sales/query/
Page 9
Page 10
Image 10
Page 9
Contents
R1ESU3F
User Guide
1U RAID Rack with eSATA /U3 /FW800
T E C H N O L O G I E S
FW 400 Cable
Unpacking and Overview
Front Door keys Rack Mounting kit Desktop accessories
FW 800 Cable
Hot Swapping drives
Installation
Port Multiplier Compatibility
RAID 0 Stripe set Number of drives at least
JBOD Mode Individual Drives
Port Multiplier Modes
RAID 1 or 10 Mirror set, Stripe of mirror sets
LARGE Spanned set Number of drives at least
RAID 5 Stripe set with striped parity
CLONE Mirror set Number of drives at least
Notes about Spare Drives
RAID Mode Switches SW13 - SW1-5
Configuring the Port Multiplier Using Switches Resetting the RAID
Setting or Modifying the RAID Mode
FACTORY DEFAULT SETTING
Windows users may install the JMicron HW RAID Manager application located on the SATA Controller CD, or download it from http//addonics.com/drivers/driverlist.php. In the CD, browse to Configuration Utilities → JMB393
Configuring the Port Multiplier Using the JMicron RAID Manager
Setting or Modifying the RAID Mode
Next, click the Basic RAID Configuration tab and select the type of RAID desired. Note that RAID 1 is currently disabled as an option since more than two individual drives are available, and DELETE ALL RAID is disabled since there are currently no arrays to delete. Shown below is the same set of drives being selected as a LARGE array
The RAID and Disk Information screen shown when the program was launched will now show the Port Multiplier with an Array. The drives are now listed as M0-M4, indicating they are members of the array. If spares are present individual drives added later, and the EZ switch is in the OFF position, they would be listed as S0, S1, etc. On the right pane, the RAID Level, status, capac- ity and members that are online are listed. Status will show “Normal” all mem- bers on line, “Degraded” a fault-tolerant array with a drive failure needing service, “Rebuilding” a fault-tolerant array in the process of reconstructing lost data onto a spare or “Broken” an array that has lost all data
CONTACT US
Phone Fax
