Compatibility
Duplicator is USB 2.0 compliant. Works with USB 3.0 devices at 480Mb/s. Works with the following devices:
-USB Flash media drive
-USB External hard disk
-Addonics Pocket Ultra DigiDrive (including PCMCIA storage devices or flash
storage with the Addonics adapters)
-Addonics Pocket eSATA/USB DigiDrive
-Addonics Pocket Micro SATA UDD
-Addonics Diamond or Ruby ExDrive, with or without Cipher feature, using the Addonics USB 3.0 to eSATAp Adapter
-Any of the above USB storage devices used with the Addonics CipherUSB
NOTE: Using an external power supply with storage devices that support external power is strongly recommended.
Using the Duplicator with Adapters not supplied by Addonics is not supported or recommended.
Duplicating source media encrypted using the Addonics Cipher family of products can be done without using the Cipher hardware – which will result in encrypted duplicates. This requires the Setup option Copy Area to be set to “Whole Media.”
The Duplicator can copy media formatted as FAT16, FAT32, NTFS, ext2 or ext3 with the Setup option Copy Area set to “System and Files.” Copying NTFS media this way requires target media that is larger in capacity than the source.
Quick Start
1.Insert the source device into the source slot, and any target devices desired.
2.Turn on the unit.
3.After a
4.Press OK to begin.
5.The Duplicator can operate in Asynchronous mode if it is able to contain all of the source data in internal memory – about 200MB. Otherwise it will
operate in Direct mode.
www.addonics.com
Technical Support | Phone: | Email: www.addonics.com/support/query/ |
