Addonics Technologies ZSAES256EU Front, Hard drive installation, Cipher Key, CipherChain, Phone

Front

Removable Cover

Power and Drive Activity LED

Removing the front panel:

You can remove the front panel of the enclosure to access the drive drawer of the SATA drive.

Hard drive installation:

1.Loosen the two screws from the rear panel. Pull out the interior tray from the enclosure.

2.Connect the 15-pin SATA power cable to the power connector of the hard drive. Also connect the 7-pin SATA data cable to SATA port of the hard drive.

3.Use the enclosed screws to secure the hard drive to the tray.

4.After the hard drive is installed, slide the tray back into the enclosure and then fasten the two screws properly.

4-pin Floppy

Power Connection

Secure

Drive

Here

CipherChain

Screws

Connect to

SATA Drive

RESET

HDD

Cipher

CipherChain

PWR

eSATA(to host)

Cipher Key

Connect to eSATA Host

www.addonics.com

Technical Support (M-F 8:30am - 6:00pm PST) Phone: 408-453-6212 Email: www.addonics.com/support/query/