•Scraping with an attachment such as the
•Wire brushing of concrete floors.
•Sanding with very aggressive sandpaper or sand screen discs. •Carpet restoration where shampooing & pile lifting require very
stiff brush bristles.
WARNING
To prevent injury, always remove the electrical plug from the electrical outlet before changing the polishing pad and before leaving the machine.
PREPARE THE MACHINE
FOR OPERATION
To attach the drive block or brush or other attachment, be sure the handle is “locked” in the upright position (See picture #1). Lay the floor machine on its back with the handle lying on the floor, this exposes the driving plate on the underside of the floor machine. Holding the drive block, brush or attachment in both hands and straddling the motor with your back to the handlebox, bend over and fit the three slots of the clutch plate (build into the back of the brush) over the three lugs of the driving plate. Turn the drive block, brush or attachment
CAUTION: This is the only proper way to install a drive block, brush or attachment. NEVER put a drive block, brush or attach- ment on the machine by placing it on the floor and moving the running machine over it, or by placing the machine over the block or attachment and then starting the motor.
Return the floor machine to upright position and adjust handle to operating position. Recommended handle position is close to the waist with arms extended down. Lock the cam release lever into position.
NOTE: The hardened steel cam release lever does not require extreme tightening to effectively hold the handle in position.
HOW TO OPERATE THE MACHINE
With the drive block and pad, brush or attachment in the
This activates the motor and starts the block, brush or attachment in operation. CAUTION: When leaving the machine unattended, disconnect the wall plug and return the handle to the “locked” upright position to prevent accidental starting.
TO GUIDE YOUR FLOOR MACHINE
To Right: raise handle slightly. The higher the handle is lifted, the faster the machine will move to the right.
To Left: to change direction, lower the handle until the machine travels to the left. The more the handle is lowered, the faster the movement to the left.
TO INSTALL THE OPTIONAL SOLUTION TANK
Mount the solution tank to the front of the handle and attach with mounting brackets and knobs. Position the solution tank control handle horizontally and below the switch lever of the machine and adjacent to the right handle grip.
Remove the plug from the motor housing and insert the (long) extension tube adaptor and secure at bottom of machine with the retainer. The solution tank should be used only with a showerfeed drive block or brush.
Picture #1
Picture #2
Picture #3
Switch Trigger