Admiral AAW-12CR1FHUE Installation Requirements, Installation Instructions, Power Supply Cord

WAC 8-24 USER MAN FINAL 3/2/05 12:13 PM Page 7

INSTALLATION REQUIREMENTS

•The air conditioner should be connected to the appropriate electrical receptacle as shown in the chart on Page 6 ( Receptacle and Fuse Types).

•The use of a time-delay fuse or time-delay circuit breaker is recommended.

•All wiring must comply with local and national electrical codes and be installed by a qualified electrician. If you have any questions, contact a qualified electrician.

Electrical Requirements

Power Supply Cord

NOTE: Your unit’s device may differ from the one shown.

A Reset Button B Test Button

ELECTRIC SHOCK HAZARD

•Plug into a grounded 3-prong outlet.

•Do not remove ground prong.

•Do not use an adapter.

•Do not use an extension cord.

•Failure to follow these instructions can result in death, fire, or electrical shock.

This room air conditioner is equipped with a power supply cord required by UL. This power supply cord contains state-of-the-art electronics that sense leakage current. If the cord is crushed, the electronics detect leakage current and power will be disconnected in a fraction of a second.

To test your power supply cord:

1.Plug power supply cord into a grounded 3-prong outlet.

2.Press RESET.

3.Press TEST (listen for click; Reset button will trip and pop out).

4.Press and release RESET (listen for click; Reset button will latch and remain in).The power supply cord is ready for operation.

NOTES:

•The Reset button must be pushed in for proper operation.

•The power supply cord must be replaced if it fails to trip when the test button is pressed or fails to rest.

•Do not use the power supply cord as as an off/on switch. The power supply cord is designed as a protective device.

•A damaged power supply cord must be replaced with a new power supply cord obtained from the product manufacturer and must not be repaired.

•The power supply cord contains no use serviceable parts. Opening the tamper-resistant case voids all warranty and performance claims.

INSTALLATION INSTRUCTIONS

Unpack the Air Conditioner

EXCESSIVE WEIGHT HAZARD

Use two or more people to move and install air conditioner.

Failure to do so can result in back or other injury.

Remove packaging materials

•Remove and properly dispose of packaging materials. Remove tape and glue residue from surfaces before turning on the air conditioner. Rub a small amount of liquid dish soap over the adhesive with your fingers. Wipe with warm water and dry.

•Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue. These products can damage the surface of your air conditioner.

•Handle air conditioner with care.

5