- 48 -

UL NOTICE: This is a "GRADE A" system.

FEDERAL COMMUNICATIONS COMMISSION (FCC) Part 15 STATEMENT
This equipment has been tested to FCC requirements and has been found acceptable for use. The
FCC requires the following statement for your information:
This equipment generates and uses radio frequency energy and if not installed and used properly,
that is, in strict accordance with the manufacturer's instruction s, may cause interference to radio
and television reception. It has been type tested and found to comply with the limits for a Class B
computing device in accordance with the specifications in Part 15 of FCC Rules, which are designed
to provide reasonable protection against such interference in a residential installation. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause interference to radio or television re ception, which can be determined by turni ng the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
•If using an indoor antenna, have a quality outdoor antenna installed.
•Re-orient the receiving antenna until interference is reduced or eliminated.
•Move the receiver away from the control/communicato r.
•Move the antenna leads away from any wire runs to the co ntrol/communicator.
•Plug the control/communicator into a different outlet so that it and th e re ceive r are on differe nt
branch circuits.
If necessary, the user should consult the dealer or an experienced radio/television technician for
additional suggestions.
The user or installer may find the following booklet prepared by the Federal Communications
Commission helpful: "Interference Handbook." This booklet is available from the U.S. Government
Printing Office, Washington, DC 20402.
The user shall not make any changes or modifications to the equipment unless authorized by the
Installation Instructions or User's Manual. Unauthorized changes or modifications could void the
user's authority to operate the equipment.

IN THE EVENT OF TELEPHONE OPERATIONAL PROBLEMS

In the event of telephone operational problems, disconnect the control by removing the plug from the
RJ31X (CA38A in Canada) telephone wall jack. We recommend that your certified installer
demonstrate disconnecting the phones on installation of the system. Do not disconnect the phone
connection inside the control/communicator. Doing so will result in the loss of your phone lines. If the
regular phone works correctly after the control/commu nicator has been disconnected from the phone
lines, the control/communicator has a problem and should be re turned for repair. If, upon
disconnection of the control/communicator, there is still a problem on the line, notify the telephone
company that they have a problem and request prompt repair service. The user may not under any
circumstances (in or out of warranty) attempt any service or repairs to the system. It must be returned
to the factory or an authorized service agency for all repairs.