Quick Startup Guide
61200176L3-1 Express 4110/4120 User Manual Quick Start-3
12. If the ISP does not support the Bandwidth Allocation Control Protocol
(BACP), navigate to the PPP parameters. Go into the Multilink field
and disable BACP.
13. If you want the 4110 to automatically disconnect from the ISP after
communication with the Internet has ceased for some period, navi-
gate to the Bandwidth parameters. Go into the On Demand field and
set Mode to On; then set Idle Timeout to the period desired. 60 sec-
onds is a commonly used value. In this mode, the 4110 will also con-
nect the second B channel when the bandwidth is not needed.
14. Arrow left until the message Save Connection List Changes appears.
Typ e y to save.
15. Go to the Configuration/IP menu and enter an IP address and net
mask into the IP Address and Subnet Mask fields. The factory
default setting will work just as well (10.0.0.1, 255.255.255.0).
16. Set the Default Gateway field to the IP address of the ISP router. If
the address of the ISP router is not known, enter a bogus address
such as 172.16.1.1 as in step 10. This setting, and the settings from
step 10, let the 4110 know to automatically call the ISP whenever you
try to access the Internet.
17. Go into the Configuration/IP/NAT submenu and set DHCP Mode to
On.
18. Arrow left to save the configuration.
19. On your computer or on the 4110 under Configuration/IP/DNS, con-
figure the DNS settings provided by the ISP. Refer to your PC’s user
manual or help screen if setting these numbers on your PC.
20. If your computer is configured to dynamically get its IP address
using DHCP, the 4110 is now ready to assign the address. The PC
must generate a DHCP request to obtain the IP parameters needed to
get on the Internet. Refer to your PC’s user manual or help screen.
If you prefer to manually connect to the ISP as opposed to letting the 4110
dynamically connect, complete steps 21-23. Otherwise, use your com-
puter to try and access the Internet, and go to step 24.
21. Go into the Dial menu.
22. Set the cursor over the Dial parameter for the Connection List profile
you just set up.
23. Press Enter; the Express 4110/4120 will start dialing.