Tap Master Owners Manual
system may be discolored due to the presence of carbon from the carbon filters, and a small amount of preservative. This is normal. DO NOT drink the first 6.5 gallons of water. Drinking from
Using Quick Connect Fittings
To remove the tubing from the fitting – push down the seal ring to the fitting body with the thumb and forefinger while simultaneously pulling on the tubing. Some mild resistance to pulling out the tubing is normal. Removing the tubing will be impossible without first fully depressurized the fitting as described in previous sections.
Make sure tubing end is smooth and round before inserting it into the fitting. NOTE: A rough or oblong tube end will leak.
Insert the tube end about a ¼” into the fitting then pull back gently to ensure a sung fit.
For more information please visit www.AdvancedWaterFilters.com or contact customer service at
Page 14
Customer Service Hotline
Tap Master Owners Manual
Tap Master Contents:
1 Instruction book: detailed descriptions, photos and troubleshooting guide.
110” Sediment
210” IRON/Carbon pre filter1: 5 micron granular activated carbon (coconut shell
carbon) with IRON filtration,
110” Carbon pre filter2: 5 micron granular activated carbon (coconut shell carbon),
110” Carbon post filter: 5 micron granular activated carbon (coconut shell carbon),
110” Artesian post filter4: 5 micron granular activated carbon (coconut shell carbon) with advanced remineralization media,
1 Thin Film Composite membrane 0.001 micron
1 UV filter3
1 Flow restriction architecture: integrated flow restrictor and water check valve, central auto
1 Drain saddle; all fittings and connecting hardware.
1 Reserve tank:
1 Chrome long reach sink faucet (or custom faucet); quick connect fittings and hardware.
1 Easy Adapter,
Maintenance Schedule
Sediment filter | annual replacement |
Carbon filter(s) | annual replacement |
IRON/carbon filter1 | 6 month replacement |
UV filter3 | annual replacement |
Membrane (50 gpd TFM) | |
Artesian filter | annual replacement |
General System Specifications
•Feed water: PSI 40 - 125 PSI
•Feed water Temperature: 40° - 100°(F)
•Max. Total Dissolved Solids (TDS): 2000 ppm
•Max. Hardness: 10 gpg
•pH limits: 4 - 10
1 | Included with Tap Master IRON and ULTRA only. | 4 Included with Tap Master Artesian only. |
2 | Included with Tap Master standard and UV only. |
|
3 | Included with Tap Master UV and ULTRA only. |
|
Page 3
Customer Service Hotline