You can attach up to one IDE (Integrated Drive Electronics) drive to the
Wire number 1 on the cable is red or blue and the other wires are gray. Connect one end to connector IDE1 on the motherboard. Make sure that the red/blue wire corre- sponds to pin 1 on the connector (in the upper right hand corner).
Connect the hard drive to the other end of the cable. Wire 1 on the cable should also connect to pin 1 on the hard drive connector, which is labeled on the drive circuit board. Check the documentation that came with the drive for more information.
IDE1
pin.1 | #IDE_RST | pin.2 | GND |
pin.3 | IDE_D7 | pin.4 | IDE_D8 |
pin.5 | IDE_D6 | pin.6 | IDE_D9 |
pin.7 | IDE_D5 | pin.8 | IDE_D10 |
pin.9 | IDE_D4 | pin.10 | IDE_D11 |
pin.11 | IDE_D3 | pin.12 | IDE_D12 |
pin.13 | IDE_D2 | pin.14 | IDE_D13 |
pin.15 | IDE_D1 | pin.16 | IDE_D14 |
pin.17 | IDE_D0 | pin.18 | IDE_D15 |
pin.19 | GND KEY |
|
|
pin.21 | IDE_DREQ | pin.22 | GND |
pin.23 | IDE_#DIOW | pin.24 | GND |
pin.25 | IDE_#DIOR | pin.26 | GND |
pin.27 | IDE_IORDY | pin.28 | GND |
pin.29 | IDE_#DACK | pin.30 | GND |
pin.31 | IDE_IRQ | pin.32 | NC |
pin.33 | IDE_DA1 | pin.34 | IDE_#P66DET |
pin.35 | IDE_DA0 | pin.36 | IDE_DA2 |
pin.37 | IDE_#CS1 | pin.38 | IDE_#CS3 |
pin.39 | IDE_#ACT | pin.40 | GND |
Chapter 2 Connecting Peripherals
17 |
