PCE-5120 User Manual 18
Chapter 2 Connecting Peripherals

2.1 Introduction

You can access most of the connectors from the top of the board while it
is installed in the chassis. If you have a number of cards installed or have
a packed chassis, you may need to partially remove the card to make all
the connections.

2.2 IDE Connectors (IDE1)

You can attach up to two IDE (Integrated Drive Electronics) drives to the
PCE-5120's built-in controller.
Wire number 1 on the cable is red or blue and the other wires are gray.
Connect one end to connector IDE1 on the single board computer. Make
sure that the red/blue wire corresponds to pin 1 on the connector (in the
upper right hand corner). See Chapter 1 for help finding the connector.
Unlike floppy drives, IDE hard drives can connect in either position on
the cable. If you install two drives to a single connector, you will need to
set one as the master and the other as the slave. You do this by setting the
jumpers on the drives. If you use just one drive per connector, you should
set each drive as the master. See the documentation that came with your
drive for more information.
Connect the first hard drive to the other end of the cable. Wire 1 on the
cable should also connect to pin 1 on the hard drive connector, which is
labeled on the drive circuit board. Check the documentation that came
with the drive for more information.
PCE-5120 offers an alternative type II CF socket of IDE port. The CF
socket and IDE port can't work at the same time. It will cause the data
conflict.
IDE1
JFP3
JFP2
JFP1
LPT1