Advantech PCM-3350 Series user manual Make sure that you do not run AWDFLASH.EXE

1.Apply power to the PCM-3350 Series with a color TFT display attached. This is the default setting for the PCM-3350 series. Make sure that the AWDFLASH.EXE and *.BIN files are located in the working drive.

Note:	Make sure that you do not run AWDFLASH.EXE
	while your system is operating in EMM386 mode.

2.At the prompt, type AWDFLASH.EXE and press <Enter>. The VGA configuration program will then display the following:

Figure 3-2: BIOS VGA setup screen

3.At the prompt, type in the BIN file which supports your display. When you are sure that you have entered the file name correctly press <Enter>. The screen will ask “Do you want to save?” If you wish to continue press Y. If you change your mind or have made a mistake press N.

4.If you decide to continue, the screen will issue a prompt which will then ask “Are you sure to program (Y/N)?” If you wish to continue, press Y. Press N to exit the program.

The new VGA configuration will then write to the ROM BIOS chip. This configuration will remain the same until you run the AWDFLASH.EXE program and change the settings.

Chapter 3 Software Configuration 2 3