Something not working?
Something not working?
If the tumble dryer is not working correctly please carry out the follow- ing checks before calling an engineer.
Symptom | Possible cause | Solution | |
| The appliance is not | Plug in the appliance | |
| plugged in | ||
|
| ||
| The fuse has blown | Check the fuse | |
| The START/PAUSE button | Press the START/PAUSE | |
The tumble dryer will not start | has not been pressed | button | |
No program has been | Select the required | ||
| |||
| selected | program | |
| The door is not properly | Close the door | |
| closed | ||
|
| ||
| The water reservoir is full | Empty the water reservoir | |
| The wrong program has | Select a different | |
| been selected | program | |
| Fluff filter blocked | Clean the fluff filter | |
| Condenser covered with | Clean the condenser | |
| fluff | ||
|
| ||
| The tumble dryer has | Observe the maximum | |
| loads stated for each | ||
| been overloaded | ||
| program | ||
|
| ||
The results are unsatisfactory | Laundry not sufficiently | Ensure the wash load is | |
| |||
| spun prior to tumble | well spun before tumble | |
| drying | drying | |
| The vent in the base of | Ensure the vent is clear | |
| the appliance is covered | ||
|
| ||
| A residue may have |
| |
| formed on the drum | Clean the inside of the | |
| interior, blocking the | drum with white vinegar | |
| sensors |
| |
| The conductivity of the | Reprogram the standard | |
The drying result is unsatis- | setting, eg. H0 instead of | ||
water in your locality dif- | |||
factory; the washing is still | H1, for dryer washing (see | ||
damp. | fers from the standard | chapter “Programming | |
setting of the appliance. | |||
| Possibilities“. | ||
|
| ||
|
|
|
28
