AEG 57700 operating instructions Programming possibilities, Purpose Execution

Programming possibilities

Programming possibilities

The electronic control system of your laundry dryer provides you with the possibility to adapt some functions of the dryer permanently to your requirements.

Purpose		Execution
"Laundry protection": If	When a drying program is set at the program selector and
	the START button has been pressed:
you want to "lock" the
	- Hold the SPECIAL CARE button depressed for five
selected drying program
	seconds.
(the selected program	The program execution display flashes for five seconds and
setting cannot be
	the laundry protection is then switched-on.
changed during the
	If an attempt is nevertheless made to change the program
drying process at the
	setting, the program execution display flashes; after
program selector or with
	pressing the SPECIAL CARE or QUICK button, it flashes for
the SPECIAL CARE or	five seconds; on turning the program selector it flashes
QUICK button):
	until the program selector is returned to the initial setting.
When "Washing
	To cancel the laundry protection:
Protection" is enabled,
	- Hold the SPECIAL CARE button depressed for five
the drying programme
	seconds.
always runs at reduced
	The program run indicator flashes for five seconds, then it
heater power (SPECIAL
	is lit steady for five seconds; laundry protection is
CARE Function).
	cancelled.
	1)	Ensure that the program selector is not in the setting
		LIGHT or OFF.
	2)	Hold the AUDIBLE SIGNAL button depressed for at least
If you always want to be		five seconds.
reminded by an audible		The AUDIBLE SIGNAL display lights; a short audible
signal at the end of the		signal is sounded.
program:		The selected setting is therewith fixed-programmed.
	If you want to cancel this setting:
	3) Proceed as described under item 1) and 2).
		The display AUDIBLE SIGNAL disappears.
	1)	Set the programme selector to LIGHT.
If you remove	2)	Hold the AUDIBLE SIGNAL button depressed for five
condensate via an		seconds.
external condensate		The PROG. TIME display shows U for normal function
drain-off and wish to		and & for external condensate drain-off.
permanently suppress	3)	Briefly press the AUDIBLE SIGNAL button to choose
the EMPTY WATER		between U and & .
indication:	4)	Turn the program selector.
		The selected setting is therewith fixed-programmed.

33