AEG 60820 manual Installation, Unpacking

132996510.qxd 11/07/01 15.30 Pagina 83 (Nero/Process Black pellicola)

Installation

Unpacking

All transit bolts and packing must be removed before using the appli- ance.

Using a spanner, unscrew and remove the rear right-hand bolt and lay the machine on its back, taking care not to squash the hoses. This can be avoided by placing one of the corner packing pieces between the machine and the floor.

025

Remove the poly- styrene block from the bottom of the machine and release the two plastic bags which are fixed under the filter door.

2 1

Carefully remove

the right-hand bag (1) then the left-hand bag (2) by pulling them towards the centre of the machine.

Set the machine

upright and remove

the two remaining bolts from the

back.

Pull out the three plastic spacers from the holes into which the bolts

were fitted.

Plug the open holes with the plugs which you will find in the plastic bag con- taining the instruction booklet.

You are advised to keep all transit devices so that they can be refitted if the machine ever has to be transported again.

83