18
TROUBLESHOOTING
The appliance does not start or it stops during operation.
First try to find a solution to the prob- lem (refer to the table). If not, contact Service.
With some problems, the display shows an alarm code:
•
- The appliance does not fill with water.
•
- The appliance does not drain the water.
•
- The
WARNING!
Deactivate the appliance before you make the checks.
Problem | Possible cause | Possible solution |
The programme | The mains plug is not con- | Connect the mains plug. |
does not start. | nected in the mains socket. |
|
| The appliance door is open. | Close the appliance door. |
| The fuse in the fuse box is | Replace the fuse. |
| damaged. |
|
|
|
|
The delay start is set.
Cancel the delay start or wait for the end of the countdown.
The appliance does | The water tap is closed. | Open the water tap. |
not fill with water. |
|
|
| The water pressure is too | Contact your local water au- |
| low. | thority. |
| The water tap is clogged or | Clean the water tap. |
| there is limescale on it. |
|
| The filter in the water inlet | Clean the filter. |
| hose is clogged. |
|
| The water inlet hose has a | Make sure that the position |
| kink or a bend. | of the hose is correct. |
| The | Close the water tap and |
| There are water leakages in | contact Service. |
| the appliance. |
|
The appliance does | The sink spigot is clogged. | Clean the sink spigot. |
not drain the water. |
|
|
|
|
|
The water drain hose has a kink or a bend.
Make sure that the position of the hose is correct.
After the checks are completed, acti- vate the appliance. The programme continues from the point of interrup- tion.
If the problem occurs again, contact Service.
If the display shows other alarm codes, contact Service.
