Installation
Electrical Connection
Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person.
WARNING – THIS APPLIANCE MUST BE EARTHED
The manufacturer declines any liability should these safety measures not be observed.
Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance rating plate. The rating plate is inside, on the left.
The appliance is supplied with a 13 amp plug fitted. In the event of having to change the fuse in the plug supplied, a 13 amp ASTA approved (BS 1362) fuse must be used.
Defrosting
Refrigerator
Frost is automatically removed from the evaporator of the refrigerator com- partment every time the motor compressor stops, during normal use. The defrost water drains out through a trough into a special container at the back of the appliance, located over the motor compressor, where it evapo- rates.
Freezer
The freezer compartment, however, will become progressively covered with frost. This should be removed with the special plastic scraper provided, whenever the thickness of the frost exceeds 4 mm. During this operation it is not necessary to switch off the power supply or to remove the foodstuffs.
However when the ice becomes very thick on the inner liner, complete defrosting should be carried out as follows:
Important!
The wires in the mains lead are coloured in accordance with the fol- lowing code:
Green and Yellow Earth
BlueNeutral
BrownLive
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured mark- ings identifying the terminals in your plug, proceed as follows:
GREEN & YELLOW
13 AMP. FUSE
13 AMP |
BROWN
BLUE
CORD CLAMP
D207
1. | Remove the frozen food from the freezer, wrap it in several layers of new- |
| spaper and put it in a very cool place. |
2. | Switch off the appliance and pull out the plug, or turn the temperature |
| control knob to “0”. |
3. | Leave the freezer compartment door open. |
4. | Insert the plastic scraper into the |
| recess provided under the defrost |
| water channel and place a collecting |
| basin under it. |
5. | Once defrosting is completed keep |
| the scraper handy for future use; |
6. | Turn the thermostat knob to the |
1.The wire coloured green and yellow must be connected to the terminal marked with the letter “E” or by the earth symbol or coloured green and yel- low.
2.The wire coloured blue must be connected to the terminal marked “N” or coloured black.
3.The wire coloured brown must be connected to the terminal marked “L” or coloured red.
4.Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath.
Warning! A
required setting or replace the plug |
in the power socket. |
Warning! |
Never use metal tools to scrape off the frost
Do not use a mechanical device or any artificial means to speed up the thawing process other than those recommended by the manufacturer.
A temperature rise of the frozen food packs, during defrosting, may shor- ten their safe storage life.
18 | 11 |
