30 English
not shown
RELEASE button below the water tank. Releasing device of the water tank
Instructions
Unpacking
•Remove any protective foils and stickers from the soleplate.
•Please unwind the lead completely.
Electrical connection
•Make sure that the iron voltage (see name plate) and the line voltage match.
•The mains plug should only be inserted into a cor- rectly installed 230 V ~ 50 Hz socket with earthing contact.
Connected Wattage
The station has a total maximum wattage of 2200 W. With this connected load a separate supply line protect- ed by a 16 A household circuit breaker is recommended.
CAUTION: OVERLOAD!
•If you use extension leads, these should have a cable
•Do not use any multiple sockets, as this device is too powerful.
Temperature Control on the Iron (3)
The symbols on the control correspond to the following settings:
• | (Synthetics, silk) | low temperature |
• • | (Wool ) | medium temperature |
• • • | (Cotton, linen) | highest temperature |
Water Tank (8)
•The water tank has a recessed grip on the bottom so that it can be removed.
•The lock of the water tank is also the lime filter cartridge. Take out the lime filter cartridge to fill with water.
•The tank volume is 1.7 litres.
Water
Use only tap water or distilled water.
Do not fill battery water, water from the clothes dryer and water containing additives (such as starch, perfume, softener or other chemicals) into the water reservoir.
This could damage the iron due to residues forming in the steam chamber. These residues may cause impuri- ties to the fabric when dropping out of the holes in the soleplate.
Operation
Before Initial Use
•Clean the ironing base with a slightly damp cloth.
•In order to remove all residues before initial use, please pass the iron a few times over an old clean cloth.
Ironing without steam
NOTE:
•Sort out the garments according to their ironing temperatures.
•Always set the temperature control to „MIN“ before connecting the appliance to a power point, or before disconnecting it.
•Place the iron on the rest (6).
•Only connect the machine to a properly installed safety socket, 230 V/50 Hz.
•Set the temperature on the temperature control (3). If you have sensitive items to iron, please begin with the lowest temperature.
NOTE:
The control lamp (1) on the iron shows that it is heating up. As soon as the control lamp goes off the operating temperature has been reached. Now you can start ironing.
•Always turn the temperature control to „MIN“ after use and remove the mains plug (the control lamp in the handle goes off).
Steam Ironing
WARNING:
The iron expels a large quantity of hot steam. Danger of burns.
CAUTION:
•When using the steam iron please ensure that the water tank is always filled to the required level.
•The lime filter cartridge always has to be positioned in the water tank, even if you use distilled water.
CAUTION: INITIAL USE:
Please proceed as follows:
•The tank should only be filled up to the maximum mark. Do not overfill!
•Close the water tank and place it back in the base.
•Connect the base station to a 230 V / 50 Hz socket with earthing contact.
•Set the desired temperature within the range „• •“ to „• • •“. The control lamp on the iron lights up.
•Wait until the soleplate has heated up. Once the temperature has been reached the control lamp goes off.
