Control Panel - DD 8990
•Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated.
Turn the hood on a few minutes before you start cooking.
The hood should be left on after cooking for about 15 minutes or until all the odours have disappeared.
The control switches are located on the hood’s front panel:
3a b
1 | 2 | 4 | 5 | 6 | 7 |
Fig. 2
1- ON
OFF: all the functions are switched off except the illumination.
2 - Light ON/OFF
3 - Display
4- Manual(stand by)/Automatic (sensors - Led “S” will illuminate). Press once to switch ON the Automatic mode, press again to switch OFF
Automatic function:
The hood switch ON (extraction) on the basis of the change in the normal environmental conditions that the hood notices through its sensors (see next page – “Sensor test”) .
The leds of the display will turn on alternatively in proportion to the suction power setting.
Attention! The hood is equipped with an automatic system that establishes what the normal environmental conditions are.
In the case of abnormal operation, calibration can be carried out automatically or manually (see next page – “Automatic calibration” and “Manual calibration”).
5- Start and choice of motor speed
6- Intensive speed on/off. The Intensive speed runs for 5 minutes: If the hood is on when the Intensive speed is activated, the hood will revert to previous speed after 5 minutes.
If the hood is off when the Intensive speed is activated, the hood
65