AEG K 9 18 00-4 I Regulations, Standards, Guidelines, Installation Location

Installation

Installation Location

The appliance should be set up in a well ventilated, dry room.

Energy use is affected by the ambient temperature. The appliance should therefore

–not be exposed to direct sunlight;

–not be installed next to radiators, cookers or other sources of heat;

–only be installed at a location whose ambient temperature corresponds to the climate classification, for which the appliance is designed.

The climate classification can be found on the serial plate, which is located at the left on the inside of the appliance.

The following table shows which ambient temperature is correct for each climate classification: each climate classification:

Climate classification	for an ambient temperature of
SN	+10 bis +32 °C
N	+16 bis +32 °C
ST	+18 bis +38 °C
T	+18 bis +43 °C

If installation next to a source of heat is unavoidable, the following mini- mum clearances must be maintained at the sides of the appliance:

–for electric cookers 3 cm;

–for oil and coal fired ranges 30 cm.

If these clearances cannot be maintained a heat insulating pad is required between the cooker and the refrigeration appliance.

Changing the light bulb

Warning! There is a risk of electric shocks! Before changing the light bulb, switch off the appliance and unplug it, or pull the fuse or the circuit breaker.

Light bulb data: 220-240 V, max. 15 W

1.Unplug the mains plug.

2. To change the light bulb press on the rear hook and at the same time slide the cover in the direction indicated by the arrow.

3. Change the defective light bulb.

4.Refit the light bulb cover.

5.Put the refrigerator back into opera- tion.

Regulations, Standards, Guidelines

This appliance was designed for household use and was manufactured in accordance with the appropriate standards. The necessary measures in accordance with appliance safety legislation regulations (GSG), accident prevention regulations for refrigeration appliances (VBG 20) and the regu- lations of the German Society of Electrical Engineers (VDE) were observed in the manufacture of this appliance.

The refrigerant circuit has been checked for leaks.

This appliance is in accordance with the following EU guidelines:

–73/23/EWG dated 19 February 1973 - low voltage guidelines.

–89/336/EWG dated 3 May 1989

Your appliance needs air

For safety reasons, minimum ventilationmust be as shown Fig.

Attention: keep ventilation ope- nings clear of obstruction;

50 mm	min.
	200 cm2
	min.
	200 cm2
D567

(including guideline change notice 92/31/EWG) - EMV guideline

22 31