AEG K 9 18 00-4 I Electrical connection, Prior to Initial Start-Up, Rehingeing the door

Malfunction Possible Cause Remedy

Rehingeing the door

	Temperature is not properly
	adjusted.
	Door was open for an exten-
	ded period.
The food is too warm.	A large quantity of warm
	food was placed in the
	appliance within the last 24
	hours.
	The appliance is near a heat
	source.

Please look in the "Initial Start Up" section.

Open the door only as long as necessary.

Turn the temperature regula- tor to a colder setting tempo- rarily.

Please look in the "Installation location" section.

The appliance’s door has been locked in position for transport by means of pins on both sides.According to the door opening direction, remove relevant pins at the top and at the bottom.

Warning! When changing the side at which the door opens, the appliance may not be connected to the mains. Remove plug from the mains beforehand.

Housing dimensions

Height	1780mm
Depth	550 mm

Interior lighting does not work.

Heavy build up of frost, possi- bly also on the door seal.

Unusual noises.

Light bulb is defective.

Door seal is not air tight (pos- sibly after changing over the hinges).

Appliance is not level.

The appliance is touching the wall or other objects.

A component, e.g. a pipe, on the rear of the appliance is touching another part of the appliance or the wall.

Please look in the "Changing the Light Bulb" section.

Carefully warm the leaking sections of the door seal with a hair dryer (not hotter than approx. 50 °C). At the same time shape the warmed door seal by hand such that it sits correctly.

Readjust the feet.

Move the appliance slightly.

If necessary, carefully bend the component out of the way.

Width 560 mm

Electrical connection

Before initial start-up, refer to the appliance rating plate to ascertain if sup- ply voltage and current values correspond with those of the mains at the installation location.

e.g.:	AC	220 ...	240 V	50 Hz or
	220 ...	240 V~	50 Hz

(i.e. 220 to 240 volts alternating current, 50 Hertz) The rating plate is inside the appliance on the left.

A correctly installed, earthed socket is required for the electrical supply. The supply must have a fuse rating of at least 10 Amps.

If the socket is not accessible once the appliance is built in, the electrical installation must include suitable means of isolating the appliance from the mains (e.g. fuse, cut-out, current trip or similar with a minimum contact separation of 3 mm).

Attention: The mains connection cable may only be replaced by a skilled electrician. Please contact your dealer or our customer service department

The compressor does not start	This is normal, no error has	The compressor starts after a
immediately after changing	occurred.	period of time.
the temperature setting.
Water on the floor or on sto-	Water drain hole is blocked.	See the "Cleaning and Care"
rage shelves.		section.

for repairs.

Prior to Initial Start–Up

•Please clean the appliance interior and all accessories prior to initial start- up (see section: “Cleaning and Care”).

30 23