AEG K 9 18 00-4 I Cleaning and Care, Temperature display, Starting Up Setting the Temperature

Cleaning and Care

For hygienic reasons the appliance interior, including interior accessories, should be cleaned regularly.

Warning!

•The appliance may not be connected to the mains during cleaning. Dan- ger of electrical shock! Before cleaning switch the appliance offand rem ve the plug from the mains, or switch off or turn out the circuit breaker or fuse.

•Never clean the appliance with a steam cleaner. Moisture could accumu- late in electrical components, danger of electrical shock! Hot vapours can lead to the damage of plastic parts.

•The appliance must be dry before it is placed back into service.

Attention!

•Ethereal oils and organic solvents can attack plastic parts, e.g.

–lemon juice or the juice from orange peals;

–butyric acid;

–cleansers which contain acetic acid.

Do not allow such substances to come into contact with appliance parts.

• Do not use any abrasive cleansers.

1.Remove frozen food and the food from the refrigerator. Wrap frozen food in several layers of newspaper. Store it in a cool place, well covered.

2.Switch the appliance off and remove the plug from the mains, or switch off or turn out the circuit breaker or fuse.

3.Clean the appliance and the interior accessories with a cloth and lukewarm water. Commercially available dish washing detergents may also be used.

4.After cleaning wipe with fresh water and rub dry.

Temperature display

The temperature display can indicate several pieces of information.

•During normal operation, the temperature currently present in the fridge (ACTUAL temperature) is displayed.

•When the temperature is being adjusted a flashing display indicates the fridge temperature currently set (DESIRED temperature).

Starting Up - Setting the Temperature

1.Plug the mains plug into the mains socket.

2.If the display is OFF press ON/OFF button. The green mains pilot indicator illuminates. The appliances start.

3.Press either the „C“ (+) or „E“ (-) button. The temperature display switches over and the DESIRED temperature currently set flashes on the temperatu- re display.

4.Set the required temperature by pressing the „C“ (+) or „E“ (-) buttons (see section "Temperature setting buttons"). The temperature display will imme- diately show the changed setting. Each time the button is pressed the tem- perature is adjusted by 1 °C.

From a food safety point of view +5 °C should be considered sufficiently cold for storing food in the fridge.

5.Once the required temperature has been set, after a short period (approx. 5 sec.) the temperature display will change and again indicate the current ACTUAL temperature inside the fridge. The display will change from flashing to continuous illumination.

Information! When the setting is changed, the compressor does not start immediately if automatic defrosting is currently taking place. As the stora- ge temperature within the fridge is reached quickly you can store food immediately after switching on.

Accumulation of dust at the conden- ser increases energy consumption. For this reason carefully clean the condenser at the back of the appliance once a year with a soft brush or a vacuum cleaner.

5.Check the water drain hole on the rear wall of the fridge. Clear a blocked drain hole with the aid of the green peg in the pack of acces- sories included with the appliance.

6.After everything is dry place applian- ce back into service.

D037

COOLMATIC

The COOLMATIC function is suited for quick cooling of large quantities of goods in the refrigerator.

1.The COOLMATIC function is switched on by pressing the COOLMATIC but- ton. The yellow light illuminates.

The COOLMATIC function now provides for intensive cooling. The COOL- MATIC function is ended automatically after a period of 6 hours.

2.The COOLMATIC function can be ended manually at any time by pressing the COOLMATIC button again. The yellow light goes out.

28 25