2
1
ENGLISH 23
9.Clean the filter under the water tap and put it back in the pump into the special guides.
10.Make sure that you tighten correctly the filter to prevent leakages.
11.Put the flap back and close the drain pump door.
THE INLET HOSE FILTER AND | • The indicator of button | 4 | flashes and | |
THE VALVE FILTER | the display shows the | related alarm. Re- | ||
It could be necessary to clean the filters | fer to 'Troubleshooting'. | |||
WARNING! | ||||
when: | ||||
Disconnect the mains plug from | ||||
• The appliance does not fill with water. | ||||
the mains socket. | ||||
| ||||
•The appliance fills with the water for a long time.
To clean the water inlet filters:
1. Close the water tap.
2. Remove the water inlet hose from the water tap.
3. Clean the filter in the inlet hose with a stiff brush.
4. Remove the inlet hose behind the appliance.
5. Clean the filter in the valve with a stiff brush or a towel.
45° |
20° |
6.Install again the inlet hose. Make sure that the couplings are tight to pre- vent leakages.
7.Open the water tap.
EMERGENCY DRAIN
Because of a malfunction, the appliance cannot drain the water.
If this occurs, do steps (1) through (6) of 'To clean the drain pump'.
If necessary, clean the pump.
Put the drainage duct back and close the drain pump flap.
When you drain the water with the emer- gency drain procedure, you must activate again the drain system:
