AEG Thyro-P REMARKS ON THE PRESENT OPERATING INSTRUCTIONS AND THYRO-P

These operating instructions refer to latest technical speciﬁ cation of Thyro-P at the time of publi-

cation and are for information purposes only. Every effort has been taken to ensure the accuracy of

this speciﬁ cation, however, in order to maintain our technological lead and for product enhance-

ment, we are continually improving our products which could, without notice, result in amendments

or omissions to this speciﬁ cation. AEG PS cannot accept responsibility for damage, injury, loss or

expenses resulting therefrom.

These operating instructions for Thyro-P are organized so that all work required for commissioning,

maintenance and repair may be performed by corresponding specialist personnel.

If hazards to personnel and property cannot be excluded for certain work, then this work is marked

using certain icons. The meaning of these icons may be found in the prior chapter safety regula-

tions.

ABBREVIATIONS

In this description, the following speciﬁ c abbreviations are used:

AEG PS = AEG Power Solutions GmbH

ASM = automatic synchronization in multiple Power Controller application

(dynamic network load optimization)

DaLo = data logger (fault storage)

LBA = lokal operating and display unit

SEK = cabinet installation kit

LL = ﬁ bre optic

LLS = ﬁ bre optic transmitter

LLE = ﬁ bre optic receiver

LLV.V = ﬁ bre optic distribution supply

LLV.4 = ﬁ bre optic distribution, 4-fold

SYT = synchronized clock

TAKT = Pulse full cycle

Customer shall provide written particulars, enclosing the delivery note, within 8 working days to

AEG PS on becoming aware of any defects in the goods during the Warranty period and shall use

its best endeavours to provide AEG PS with all necessary access, facilities and information to

enable AEG PS to ascertain or verify the nature and cause of the defect and carry out its warranty

obligations.

If goods are found not to be defective or if any defect is attributable to Customer’s design or mate-

rial in operation of the goods, AEG PS will levy a testing charge and where relevant will return the

goods to Customer at Customer’s expense, and shall be entitled to payment in advance of the

whole testing and transport charge before such return.

AEG PS accepts no liability for defects caused by the Customer’s design or installation of the

goods; or if the goods have been modiﬁ ed or repaired otherwise than as authorised in writing by

AEG PS; or if the defect arises because of the ﬁ tting of the goods to unsuitable equipment.

AEG PS will cancel all possible obligations incurred by AEG PS and its dealers, such as warranty

commitments, service agreements, etc., without prior notice if other than original AEG spare parts

or spare parts purchased from AEG PS are used for maintenance or repair.

REMARKS ON THE PRESENT OPERATING INSTRUCTIONS AND THYRO-P