Aegis Micro AEG-WR installation manual Quick-Referencesetup Guide

QUICK-REFERENCE SETUP GUIDE

To Enter Set Up mode, press and hold the Mode/Advance switch for 2 seconds.

DISPLAY	DESCRIPTION
C 0	Enter the first digit of the code
C 0.	Enter the second digit of the code
C.0	Enter the third digit of the code
C.0.	Enter the fourth digit of the code
A 1	Enter the receiver address
n 1	Enter number of addresses
C 1	Displays the first digit of the code
C 1.	Displays the second digit of the code
C.1	Displays the third digit of the code
C.1.	Displays the fourth digit of the code

1Displays the status of transmitter 1

2Displays the status of transmitter 2

3Displays the status of transmitter 3

SET SWITCH

Increments the digit (0-9) Increments the digit (0-9) Increments the digit (0-9) Increments the digit (0-9)

Changes the current address (1-8) Changes number of addresses (1-4) Changes the current digit (0-9) Changes the current digit (0-9) Changes the current digit (0-9) Changes the current digit (0-9) Changes characteristics of transmitter Changes characteristics of transmitter Changes characteristics of transmitter

MODE/ADVANCE SWITCH Advances to the next digit Advances to the next digit Advances to the next digit Advances to the next item Advances to the next item Advances to the next item Advances to the next digit Advances to the next digit Advances to the next digit Advances to the next item Advances to the next transmitter Advances to the next transmitter Advances to the next transmitter

Characteristics of Transmitters:

DISPLAY	MODE LED	TYPE LED	DESCRIPTION OF THE DISPLAY
1	OFF	OFF	No transmitter is programmed at this address
1*	OFF	BLINKS	This transmitter is not supervised and doesn't send restore transmissions
.1*	ON	BLINKS	This transmitter is not supervised but sends restore transmissions
1.	OFF	ON	This transmitter is supervised but doesn't send restore transmissions
.1.	ON	ON	This transmitter is supervised and sends restore transmissions

To reset memory, press and hold the Set and Mode/Advance switches together for 2 seconds.

DISPLAY	DESCRIPTION	SET SWITCH	MODE/ADVANCE SWITCH
C 0	Enter the first digit of the code	Increments the digit (0-9)	Advances to the next digit
C 0.	Enter the second digit of the code	Increments the digit (0-9)	Advances to the next digit
C.0	Enter the third digit of the code	Increments the digit (0-9)	Advances to the next digit
C.0.	Enter the fourth digit of the code	Increments the digit (0-9)	Advances to the next item
E E	Erase EEPROM ? (Reset Memory)	Press and hold Set & Mode/Advance switches together for 2 seconds