Remote control operation
Operating range
You can operate the projector with the remote control within the remote range 15 m (49'2"), approximately
± 30° vertically and horizontally.
Facing to the projector
Make sure the remote control emitter is facing to the remote control signal receptor of the projector when pressing the buttons to operate.
Facing to the screen
Make sure the remote control emitter is facing to the screen when pressing the buttons to operate the projector. The signal will be reflected off the screen to the projector.
The operating range may differ due to the screen material, and this function may not be effective with a translucent screen.
NOTE:
• See “About Your Projector” on page 12 to confirm the position of the remote control signal emitter and receptor.
• Do not let strong light shine onto the signal receptor. The remote control may malfunction under strong light such as fluorescent.
• If there are any obstacles between the remote control emitter and the remote control signal receptor, the remote control may not operate correctly.
Setting up the image position automatically
If you need to readjust the projected image |
|
|
position while projecting or when AUTO SETUP |
|
|
in OPTION menu is set to OFF, press the AUTO |
|
|
SETUP button. |
|
|
The projector will detect a RGB signal by SIGNAL |
|
|
SEARCH system and adjust the setting of POSITION, |
|
|
DOT CLOCK and CLOCK PHASE in POSITION menu | Screen | Projected image |
automatically. |
|
|
NOTE:
•If SIGNAL SEARCH setting in OPTION menu is set to OFF, select the required signal manually first. See “Switching the input signal” on page 24.
•If the dot clock frequency is 108 MHz or higher, AUTO SETUP is not effective.
•If the projected image is too dark or blurred around the edge, AUTO SETUP may stop the processing before complete the adjustment and return to the previous setting. Project a much clearer or lighter image and try again.
