AeroGarden 100302-SLR AeroGarden3 Control Panel, Remove Bio-Domes, Water Level Low, Reset

Basic Reminders About Your AeroGarden

AeroGarden3 Control Panel

RESET

Use to reset “Add Nutrient” and “Replace Bulb” timers when each light illuminates.

LIGHT On/Off

Use to occasionally override built-in light timer. Once pushed, light will stay off/on until the next time built-in light timer is set to go on/off. This will not affect the timing of your light cycle, and oc- casional use of this feature will not harm your plants.

Add	Replace
Nutrient	Bulb

ADD NUTRIENT (Feed Garden - Basic Feeding) When “Add Nutrient” light illuminates (every 2 weeks), add 1 nutrient tablet and fill Bowl with water up to “Fill To Here.”

Press and hold “Reset” button until “Add Nutrient” light blinks (3 seconds). Release “Reset” button, then press and release again. “Add Nutrient” light will go off and timer is now reset.

REPLACE BULB*

When light illuminates (after 6 months of use), it is time to replace Grow Bulb. Order bulbs at www.aerogardensupport.com or from your retailer.

After replacing Grow Bulb, press and hold “Reset” button until “Replace Bulb” light blinks (3 seconds). Release “Reset” button, then press and release again. “Replace Bulb” light will go off and timer is now reset.

*See complete replacement instructions on page 11.

REMOVE

BIO-DOMES

When plants appear through hole in Seed Pod Label, remove Bio-Domeand discard or recycle.

Note: Never remove Seed Pod Labels.

“Fill To Here”

FILL	TO
HERE

WATER

LEVEL LOW

When water level indicator is RED, add water to “Fill To Here.”

9