5Reassemble Pump
AWith Grow Surface upside down, insert the Pump back into the Pump Tower making sure that:
•The Rubber Feet of the Pump are facing up.
•The Face Plate is facing toward you. 
•Pump is securely seated in the tube in the Pump Tower. 
•The Pump Wire goes behind and underneath the Pump, and
lines up with Wire Slot.
BInsert Cover Plate in the bottom of the Pump Tower and push down until all corners snap in place.
C Push Pump Wire back in
Wire Slot.
DTurn Grow Surface right side up and place clean or new Filter back in slots in front of the Pump. (If you do not have a Filter, please see Troubleshooting on page 6.)
If you are working with a planted AeroGarden, skip step E (below) and proceed to final steps on page 7.
EReplace Grow Surface in Bowl*.
Congratulations!
Your AeroGarden is ready for its next planting!
*If you cleaned your Pump to reduce noise, fill the Bowl with water and plug in your AeroGarden. If the Pump is still noisy, please contact Customer Service.
Page 6
