AeroGarden Components (continued)
Grow Surface (upside down)
Cover Plate
Pump located behind Filter
Filter
Pump Tower
Wire Slot | Pump Wire | Pump Connector |
| Contact Strips | |
|
|
1Remove & Save AeroGarden Water & Seed Pods
Skip this step if your AeroGarden is not planted and proceed to Step 2 on page 3.
AUnplug your AeroGarden.
BRemove Bowl from Base.
CRemove Grow Surface and place in sink (or on towel) as roots will drip water.
DPour water from Bowl into shallow dish to a depth of 1”.
EPour remaining water from Bowl into container that holds at least 1 gallon and set aside.
FGently remove Seed Pods from Grow Surface* and place plants upright in shallow dish. Be sure roots are in water.
Don’t worry if you tear a few roots or if the Cross Beams come out with the roots. Cross Beams can easily be placed back in position (see Troubleshooting for instructions).
1 Gallon Container
Grow Surface
Baking Dish
*Use the illustration and corresponding numbered spaces to indicate where Seed Pods are located in the Grow Surface Openings so you can replace them in the same position later.
1.5.
2.6.
3.7.
4.
Page 2
