B. TO REMOVE SIDE PANELS
1. Isolate from electric supply.
2. Lower the cooker onto the rollers by turning the adjusting feet fully anti-clockwise.
NOTE: It may be necessary to disconnect the flexible gas connection to allow the cooker
to be withdrawn from between the kitchen units.
3. Roll the cooker slightly forward, unhook the safety chain and disconnect the flexible hose.
4. Remove rear fixing screws (6) and slide side panel back and out.
5. Re-assemble in reverse order.
C. TO REMOVE FACIA CASTINGS
1. Isolate from electric supply.
2. Proceed as ‘TO REMOVE HOTPLATE CASTINGS’.
3. Pull off control knobs.
4. Remove control panel fixing screws (4) (See Fig. 23). When removing the screws support
the casting.
NOTE: When removing the casting, the oven indicator neons and the timer cables require
disconnecting from the facia. To disconnect the neons, hold the cable at their entry into
the neon, twist and pull, this will disengage the neon assembly. To disconnect the timer,
pull the cables off their terminals taking care to identify cable connections. Be careful when
re-fitting facia casting, to position neon and wires correctly.
46
Fig. 23
Fig. 22
DESN 513509
DESN 513523