SERVICING - WARNING
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
Servicing Notes
When servicing or replacing gas carrying components disconnect from gas before commencing operation and check appliance is gas sound after completion. When checking for gas leaks use a liquid leak detector at all joints and connections to check for leaks in the system. Use a product specifically manufactured for leak detection. Leak testing of the appliance shall be conducted in accordance to the manufacturer’s instructions.
Reassemble in reverse order. When replacing leads refer to the wiring diagram. Check operation of timer, ignition, and oven light switches.
3. To Remove the Cooktop
Disconnect from electricity supply.
Remove the grates, cooktop burner caps and tops. If there are screws holding the cooktop burners to the cooktop, remove them (not the spark electrode fixing screws).
CAUTION: DO NOT USE A FLAME TO CHECK FOR GAS LEAKS.
Do not use
Disconnect from electricity supply before commencing servicing, particularly before removing any of the following: control panel, side panels, cooktop tray, or any of the electrical components or cover boxes. Before electrical reconnection make sure the range is electrically safe.
1. To Remove the Hand Rail
Remove the handrail plastic blanking plugs and remove the 2 end bracket fixing screws.
2. To Remove Control Panel
Disconnect from electricity supply.
Pull off all the control knobs. Remove the hand rail (see 2) Remove the 2 cross headed screws that were hidden by the hand rail end brackets.
Open the broiler door and R H oven door and remove the 2 screws underneath the control panel.
ACooktop front fixing screws
BCooktop rear fixing screws
Remove the 2 rear cooktop fixing screws (B) and the 4 front cooktop fixing screws (A).
Remove the screws holding the flue grille stays and if the rear extenstion is fitted remove the screws holding that as well.
Lift the cooktop clear of the appliance. Replace in reverse order.
Reassemble in reverse order ensuring that the leads are reconnected. When replacing the cooktop take care not to damage the ignition electrodes
Check for correct burner operation.
Pull the control panel forward and support so that the wires are not strained.
4
