SERVICING - WARNING
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
16. To Change Oven Door Catch
Remove outer door panel (see 15). Remove screws ‘B’ holding catch assembly to inner door panel. Fit new catch and reassemble in reverse order.
Check correct door operation.
18. To Adjust Oven Door Catch Keep
Open oven door, slacken off locknut at base of keep, and screw in or out as required until required fit is obtained. Retighten locking nut.
19. To Change Ignition Generator
Disconnect from electricity supply.
Pull cooker forward to gain access to the cover box at the rear of the left hand cooker. Remove the screws securing the cover and lift clear. Pull off all the leads to the generator noting their positions. Slacken the two screws holding generator to cooker and remove generator.
Fit new generator to cooker and replace leads. Reassemble in reverse order. Refer to wiring diagram. Check ignition performance.
17. To Change Oven Door Seal
Open oven door. The seal is held in place by small hooks on the rear face. At the corner pull seal diagonally away from the door centre until that hook is released. Proceed to the next hook and release it in a similar way, and so on.
20. To Remove Oven Inner Back.
Open the oven door. Remove oven furniture. For the LH oven unscrew the 2 thermostat phial fixing screws.
Fig. 4
When fitting new seal, position the seal join at the bottom. Hook the new seal in one of the corner holes of the door, and proceed round the door snapping in each hook in turn.
Remove the fixings that secure the inner back to the oven rear. Lift the removable panel away.
8
