SERVICING - WARNING
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
7. To Remove a Thermostat
Remove control panel (see 2) and cooktop (see 3). Open the appropriate oven door and remove the oven shelves.
RH oven
Remove oven roof. Remove the two fixings that secure the thermostat phial cover. Unclip the thermostat phial from the clips in the oven back panel & remove from the top rear of the oven.
LH oven
Remove the two screws holding the thermostat phial to the oven fan cover at the rear of the oven. Pull the unit forward to access the rear of the cooker. Remove both rear cover boxes by removing the fixing screws and lifting clear. Feed the thermostat capillary clear of the oven. Disconnect the wires from the thermostat and undo the two fixings that secure the control to the mounting plate. Fit the replacement and re- assemble in reverse order. Ensure that the phial is clipped to the oven rear, positioned centrally between the clips. Check that the thermostat functions correctly.
8. To Change Broiler Controller
Remove the control panel (see 2) and cooktop (see 3). Disconnect wiring from controller. Remove 2 screws holding switch/controller to mounting panel. Fit new controller and reassemble in reverse order. Check for correct operation.
BEFORE SERVICING ANY GAS CARRYING COMPONENTS TURN OFF GAS SUPPLY.
9. To Change a Cooktop Tap
10. To Change a Cooktop burner orifice
Standard burner | Wok burner |
A orifice, B internal orifice, C external orifice
Remove burner cap and head. Remove old orifice. Fit new orifice. Note the Wok burner has 2 orifices. Reassemble in reverse order. Check appliance is gas sound.
11. To Change Cooktop Burner Electrode
Lift off hoplate pan supports, remove burner cap. Remove the screw holding the electrode. Pull electrode vertically up sufficiently to grip the lead between thumb and forefinger. Pull off the electrode, but keep hold of the lead. Fit new electrode to the lead. Fix electrode in burner with screw. Replace burner cap. Check the burner ignition. Replace pan supports.
Remove the cooktop top, see 3. Undo the nut at rear of the valve and remove the screw(s) securing valve to gas rail. Remove old valve, discard old gasket/seal. Fit new gasket/seal to new valve.
Reassemble in reverse order. Check valve is adjusted for correct gas. Check cooker is gas sound.
6
